I've been called to plenty of houses where the water was still running because nobody knew where to turn it off. A burst supply line can put out hundreds of gallons an hour. The difference between a wet floor and a gutted basement is usually a couple of minutes, and those minutes depend on knowing exactly where one valve is.
Where to look first
The main shutoff sits where the water line enters the house, so start by thinking about where that line comes from.
- Homes with a basement: check the foundation wall that faces the street. Look low, where a pipe comes through the concrete, usually right next to the water meter.
- Homes on a slab or crawlspace: check the garage, a utility closet, or the wall near the water heater. In some homes it is outside near the foundation, under a small cover.
- Homes on a private well: the shutoff is usually at the pressure tank, on the pipe leaving the tank toward the house. Turning off the well pump's breaker stops the supply too.
- Townhomes and condos: look in the utility closet or under the kitchen sink. In some buildings the shutoff for your unit is in a shared space, so ask the association where it is.
Which kind of valve do you have?
There are two common types, and they turn differently.
- Ball valve (a lever): a quarter turn does it. When the lever is across the pipe, the water is off. When it lines up with the pipe, it is on.
- Gate valve (a round wheel): turn it clockwise, righty-tighty, until it stops. It takes several full turns.
Gate valves are common in older Bucks County homes, and they have a weakness: after years of never being touched, they seize. If yours won't move with firm hand pressure, don't put a wrench on it and force it. A seized valve can snap or start leaking at the stem. Call a plumber and have it swapped for a ball valve. It is a small job that pays for itself the first time you need it.
What about the valve at the street?
On public water there is also a shutoff near the curb, called the curb stop. It belongs to the water authority and takes a special key. If your house valve fails in an emergency, call your water company. Don't try to open the curb box yourself.
Test it twice a year
Once you find it, test it. Close the valve, open a faucet to confirm the water stops, then open the valve again slowly. Doing this each spring and fall keeps it from seizing and makes sure it still works.
Make sure everyone can find it
- Hang a bright tag on the valve so it can be spotted with a flashlight.
- Show everyone in the house where it is, including teenagers and anyone who house-sits.
- Take a photo of it and of the path to it, so you can talk a family member through it over the phone.
- Keep nothing stored in front of it. You want a clear path.